Blizzard POWER PLOW 8100PP, Owner'S Manual

Page: 28 / 40

Lit. No. 40691, Rev. 05 28 May 1, 2021
REMOVING SNOWPLOW (OFF)
During the o ff -season, the control can be removed.
Disconnect the connector in the cab and store the
control in the glove box of the vehicle.
1. Lower snowplow onto ground with blade straight.
Turn control in cab OFF.
2. Move power switch to center, or "OFF," position.
3. While holding the power switch RIGHT, push
DOWN and hold the Arm/Blade Operation switch.
Arm will disengage mount adapter to relieve
tension on the stand.
REMOVING SNOWPLOW FROM VEHICLE & STORAGE
WARNING
Keep 8' clear of the blade when blade is being
raised, lowered, or angled. Do not stand
between the vehicle and blade or directly in
front of blade. If the blade hits or drops on
you, you could be seriously injured.
WARNING
Inspect snowplow components and fasteners
for wear or damage whenever mounting or
removing the snowplow. Worn or damaged
components could allow the snowplow to
drop unexpectedly.
4. Pull the stand pin out. Rotate the stand down until
the stand pin seats into the lower A-frame hole.
The stand pin must lock into the lower A-frame
hole. Push down on the top of the shoe. The shoe
will be on the ground.
5. Repeat Step 4 on the passenger's side.
6. Push and hold power switch RIGHT and push
UP the Arm/Blade Operation switch. Arm will
engage mount adapter and pull snowplow tightly
to vehicle.
7. Rotate and pull the hitch pin. Rotate the hitch pin
into the retracted position.
8. Repeat Step 7 on the passenger's side.
Light
Tower
Power
Switch
Arm / Blade
Operation
Switch
Switch
Label
ARM/BLADE
OPERATION
POWER
OFF
Raise
Lower Plowi
n g
A rm/Bl
a
d e
Opera
ti
o n
OFF
48207
Power Switch
Arm/Blade
Operation Switch
Hitch Pin
Mount
Adapter
Arm
A-Frame
Stand
Upper Hole
Stand Pin
Stand Handle
Light Tower
Boot
Blade
Shoe
OFF
Hitch
Pin
Pin
Handle
Mount
Adapter
Pin
Guide Plate