Lit. No. 40691, Rev. 05
18
May 1, 2021
Control Lever Movement
From the center position, the control lever can be
moved in one of eight directions to control various
movements of the snowplow blade. To change from
one movement of the blade to another, the control
lever must be moved back to the center position
before selecting the desired function. Whenever the
lever is released, it should spring back into the center
position to stop any blade movement.
Function
Description of Operation
RAISE
Move control lever toward top of control body to raise snowplow and cancel FLOAT mode. Function times
out after 6.25 seconds.
LOWER
Move the control lever toward bottom of control body to lower the snowplow. Release the lever to stop blade
at desired height.
FLOAT
Move the control lever to
LOWER
position and hold for .75 second to activate this
mode. The FLOAT
l
ight
in upper right corner of control face will illuminate. The blade will lower to the ground surface and follow
the contour of surface as it dips or raises. Function does not time out; however, control will shut down after
20 minutes of nonuse.
Move lever to
RAISE
position momentarily to cancel FLOAT. Angling left or right will interrupt (stop) FLOAT
function, but FLOAT will resume when angling is complete.
L
(Angle Left)
Move the control lever straight to the left to move the blade to the angle left position to cast snow to the
driver's left side. Function times out after 4.5 seconds.
R
(Angle Right)
Move the control lever straight to the right to move the blade to the angle right position to cast snow to the
driver's right side. Function times out after 4.5 seconds.
BUCKET
BLADE™
Move the control lever toward the words BUCKET BLADE on the control face to extend both wings forward
into the BUCKET BLADE position. Function times out after 7.25 seconds.
COMPACT
Move the control lever toward the word COMPACT on the control face to draw both wings into the fully
retracted position. Function times out after 5.5 seconds.
L WING
IN/OUT
Move the control lever toward the left side of LOWER on the control face to move the left wing. The
fi
rst
time the lever is moved into the slot after the control is turned ON or another function is used, the wing will
extend. Repeated use of lever in the same slot, without using another function, results in movement in the
opposite direction from the previous movement. Function times out after 4.5 seconds.
R WING
IN/OUT
Move the control lever toward the right side of LOWER on the control face to move the right wing. The
fi
rst
time the lever is moved into the slot after the control is turned ON or another function is used, the wing will
extend. Repeated use of lever in the same slot, without using another function, results in movement in the
opposite direction from the previous movement. Function times out after 4.5 seconds.
L
R
RAISE
LOWER
ON/OFF
FLOAT
COMPACT
WING
IN/OUT
3
WING
IN/OUT
WING
IN/OUT
4
WING
IN/OUT
2
1
BUCKET
BLADE™
Float Light
(green)
Control Functions
Raise, Lower, Float, Angle
Moving the control lever in straight lines up and down
or from side to side on the control body will result in
the blade movements described in the following table.
NOTE: If control function times out before desired
blade movement is complete, release the lever
to the center position, then move back into the
desired function.
OPERATING YOUR SNOWPLOW
Summary of Contents for POWER PLOW 8100PP
Page 2: ......
Page 4: ......
Page 6: ...Lit No 40691 Rev 05 6 May 1 2021 ...
