Lit. No. 68251, Rev. 09
32
May 1, 2021
4. Return to the interior of the vehicle to test the
remaining functions of the snowplow. The system
power on the control should be in the "ON"
position. Raise the snowplow to its maximum
height by pulling the joystick back (or down) or
pressing the U button on the touchpad. Initiate the
driver-side wing by pushing and holding the LEFT
WING EXTEND rocker switch on the joystick, or
LEFT WING OUT button on the touchpad, until the
wing pivots forward. Notice the staggered pace
at which the wing extends. The hydraulic
fl
uid is
fi
lling the hose and replacing the air in the system.
Push and hold the LEFT WING RETRACT rocker
switch on the joystick, or LEFT WING IN button on
the touchpad, to return the wing. Continue testing
the remaining rocker switch/button functions.
To lower the snowplow to the ground, push the
joystick ahead (or up) or push the D button on the
touchpad.
NOTE: The FLOAT function is activated when
the joystick is pushed ahead (or up) into the
"LOWER" position or the D button is pressed
on the touchpad and held there for an additional
.5 second after the blade contacts the ground.
The LED FLOAT light will come ON when the
snowplow is in FLOAT mode.
Initiate the passenger-side wing by pushing and
holding the RIGHT WING EXTEND rocker switch
on the joystick, or the RIGHT WING OUT button
on the touchpad, until the wing pivots forward.
Push and hold the RIGHT WING RETRACT
rocker switch on the joystick, or the RIGHT WING
IN button on the touchpad, to return the wing.
With both wings retracted
, check the
fl
uid level
in the reservoir and
fi
ll to 3/4" from the top of the
tank if needed.
5. Check
for
fl
uid leaks around the manifold, pump,
hydraulic hoses and all cylinders. If there are any
leaks, turn OFF the power switch on the control
and shut OFF the vehicle engine. Tighten any
loose connections and/or
fi
ttings. Restart the
vehicle, cycle through all blade controls, then
check to see if all the leaks have been stopped
after turning OFF the control power switch and
shutting OFF the vehicle.
6. Check that the vehicle and snowplow headlamps
are in proper working condition, including the turn
signals.
TESTING YOUR SNOWPLOW
ON/OFF Switch
(Emergency Stop)
ON/OFF Switch
(Emergency Stop)
Indicator
Light
Indicator Light
(Backlit)
LED Float Light
LED Float Light
