Lit. No. 43573/43583/43593, Rev. 02
10
January 15, 2017
MOUNTING THE SPREADER
8. Once the spreader is positioned front to back,
center it left to right. Looking at the inside front
and rear corner of the lower frame area, you will
notice four holes in the bottom of the frame. Using
a paint pen or similar marking device, mark hole
locations.
9. Drill holes at the marked locations.
NOTE: Pay special attention when drilling or
clamping dissimilar metals to aluminum bodies.
Galvanic corrosion can occur if not handled
properly. Contact vehicle manufacturer for
recommended attachment practices.
10. Install and tighten all four cap screws.
11. Install the four ratchet straps as shown below.
NOTE: It is important for safety that this strapping
method be used as the standard mounting
procedure.
12.
Connect the spreader power cord to vehicle
main power plug mounted at the rear of the
vehicle (refer to installation instructions for wiring
instructions).
Cross left upper to
right lower.
Strap from rear
of vehicle to front
corner (both sides).
Cross right upper to
left lower.
Tarp Kit
Ratchet Strap
CAUTION
Before drilling holes, check to be sure that no
vehicle wiring or other components could be
damaged.
Summary of Contents for ICE CHASER 78903
Page 2: ......