Page 11
TOURnado™ CSI COB User Manual Rev. C
© Copyright 2015 Blizzard Lighting, LLC
ADDR
001-512
To choose the DMX address
STAT
UV
UV intensity (0% <--> 100%)
SHUT
Flash / strobe speed (0-255)
SET
CHMD
1CH
To run in 1-channel mode
3CH
To run in 3-channel mode
DIM
(dimming)
LIN
Linear dimming curve
SQR
Square law curve
ISQR
Inverse square law curve
SCUR
S-curve
LIN.
Linear dimming curve (smooth)
SQR.
Square law curve (smooth)
ISQR.
Inverse square law curve (smooth)
SCUR.
S-curve (smooth)
DISY
ON
LED menu display is on continually
2MIN
LED menu display shuts off after 2 minutes of inactivity
LOCK
YES
If set to
YES
, the menu will lock after 2 minutes of inactivity. To
unlock, press:
<MENU>, <UP>, <DOWN>, <ENTER>, <MENU>,
<UP>, <DOWN>, <ENTER>, <MENU>, <UP>, <DOWN>, <EN-
TER>
within 3 seconds between each button press.
NO
Menu lock is off
INFO
SOFT
Vx.x
Software version information
POW
Current automated overheat protection level (100%/80%/50%)
LOAD
YES
Restore factory settings
NO
Cancel
Control Panel Menu Structure
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
Set the Starting DMX Address:
The default mode for the fixture is DMX, so the first menu item that you can edit is the
starting DMX address.
1.) Navigate the menu using the
<UP/DOWN>
buttons until you reach
Addr
.
2.) Push the
<ENTER>
button.
3.) Use the
<UP/DOWN>
buttons to select a DMX channel from
001-512
.
4.) Press the
<ENTER>
button to confirm.
Select the DMX Channel Mode:
1.) Navigate the menu using the
<UP/DOWN>
buttons until you reach
CHnd.
2.) Push the
<ENTER>
button.
3.) Use the
<UP/DOWN>
buttons to select either
1CH,
or
3CH
mode.
4.) Press the
<ENTER>
button to confirm.
Slave Mode:
1.) Daisy chain the fixtures DMX in/out, having the controller at the beginning of the line.
2.) There is nothing else to it! The first fixture in the DMX chain is the master fixture, and
the following fixtures will be slave units that follow the master fixture.
Strobe Mode:
1.) Navigate the menu using the
<UP/DOWN>
buttons until you reach
STAT
.
2.) Push the
<ENTER>
button.
3.) Use the
<UP/DOWN>
buttons to adjust the flash rate from
000-255.
4.) Press the
<ENTER>
button to confirm.
