Page 8
Solar Ray™ User Manual Rev. A
© 2015 Blizzard Lighting, LLC
Mounting & Rigging
•
The construction must be able to support 10 times the total weight of the devices.
•
The installation must always be secured with a safety cable.
•
Never stand directly below the device when it is being mounted, removed or serviced.
Have a qualified technician check the device annually and once before you bring it into
service.
•
Overhead mounting requires extensive experience: calculating workload limits, and
determining the installation material to be used. Have the material and the device
itself checked regularly.
•
For truss mounting, use an appropriate clamp (not included) and fit an M10 bolt
through the center of the mounting bracket.
•
Adjust the desired inclination angle via the mounting bracket and tighten the bracket
screws.
•
Connect the device to the mains with the power plug. All devices must be powered
directly off a grounded switched circuit. Do not connect to a dimmer pack.
•
The device has a power output to supply power to another device. When connecting
several devices in a daisy chain via this output, make sure that the total current does
not exceed the power line’s nominal current.
Making A Wall of Solar Ray™ Fixtures
1. Mount the first unit on a truss via its mounting bracket, and an appropriately rated
clamp to accommodate the total weight of connected fixtures.
2. Rotate both fixture connector plates on connecting side(s) to the extended position, and
tighten them down securely.
3. Set the next fixture in place, and fasten them together using the attached locking push-
button safety pins.
