Page 12
Q-Stick™ RGBW Manual Rev. B
Copyright (c) 2012 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the fixture is DMX, which appears as either
F
/
P
/
A
/.
001
on the LED Readout, depending on the channel mode. To se
-
lect a different DMX address, using the
<MENU>
button, select
Addr
, then hit
<ENTER>
. Use the
<UP/DOWN>
buttons to select the correct address, then
hit
<ENTER>
to confirm.
2.) To set the fixture to 4 (“A”), 5 (“P”), or 7 (“F”) channel mode, use the
<MENU>
button to select
cH--
, then hit
<ENTER>
. Use the
<UP/DOWN>
buttons to select the desired channel mode between
F.001
, (7-Channel
Mode),
P.001
, (5-Channel Mode), or
A.001
, (4-Channel Mode), then hit
<ENTER>
to confirm.
Stand-Alone, Master/Slave, Sound Active Modes:
Allows a single or Master/Slaved units to run factory installed programs at user selectable
speeds.
1.) To set the fixture in Flash/Fade mode, select
FLAS or FAdE
To confirm, press the
<ENTER>
button.
2.) Now, use the
<UP/DOWN>
buttons to select the desired speed from
000
(slowest), to
100
, (fastest), then hit
<ENTER>
to confirm.
3.) To use the fixture in automatic mode, select
ASC-
, then press the
<EN-
TER>
button to confirm.
4.) Again, use the
<UP/DOWN>
buttons to select the desired speed from
000
(slowest/off), to
100
, (fastest), then hit
<ENTER>
to confirm.
5.) To set the fixture as a slave unit, select dmx mode, channel
F.001
, and hit
<ENTER>.
Auto Mode:
Allows a single unit to display a variety of colors and programs without a DMX controller.
1.) To set the fixture in auto mode, select
AuTo
.
To confirm, press the
<ENTER>
button.
2.) Now, select the program speed by using the
<UP>
and
<DOWN>
buttons to
select
000
(slowest), to
049
, (fastest), then hit
<ENTER>
to confirm.
Sound Active Mode:
Allows the fixture to respond to sound input without a DMX controller.
1.) To set the fixture in sound active mode, first select
AuTo
.
To confirm, press the
<ENTER>
button.
2.) Now, select the sound sensitivity by using the
<UP>
and
<DOWN>
buttons
to select
050
(least sensitive), to
100
, (most sensitive), then hit
<ENTER>
to confirm.
