13. Practical recommendations
The metal detector BLISSTOOL LTC48X is designed to find metal objects buried in the ground.
It does not work well in residential areas and rich urban environment because it is highly
sensitive electronic device and is troubled by surrounding electric devices, systems with
electricity and metal objects (metal parts of the structure of the property, equipment and
furnishings of the property). Therefore, when working in residential areas, the metal detector
may be unstable, nervous, to give false signals. Typically in such conditions can not be
demonstrated and measured its maximum parameters. If you want to measure the maximum
parameters of your metal detector, do the test in terrain outside the settlement, ie where you
will search for buried metal objects. There, the metal detector has maximum appropriate
behavior and parameters.
When working with the metal detector near another metal detector, they can interfere with
each other. This is inevitable in cases where the metal detectors operate on the same or
similar operating frequency. Such are the metal detectors from the same brand and model, but
not limited, because at the same operating frequency able to work and other than their metal
detectors. Disturbance is expressed in the issuing of periodicals, evenly and pulled sounds
from the metal detector.
If during work with the metal detector, you on the call via mobile phone or your mobile phone
rings, is possible the metal detector to be troubled by it. Usually the metal detector does not
interfere with mobile phone in standby mode, except where the terrain on which you are, a
mobile operator's signal is weak or lost. In this case, even in standby mode, your mobile
phone periodically tries to connect to the nearest mobile cell of the used by you mobile
operator, with the result that it can cause a periodic disturbance of the metal detector.
One of the most important components of the metal detector is the search coil, which to a
great extend determines the device’s sensitivity.
When the metal detector is carried, for example in a rucksack or a traveling bag, an exceptional care
should be taken to avoid the bending of the coil cable near the nozzle at the base of the search coil.
That may result in tearing the cable connecting cores and damaging of the search coil and the metal
detector.
When necessary, the search coil, the electronic block box and the power supply module box
could be cleaned with wet cloth. Do not use detergents as they may damage the plastic parts
or the inscription on the front panel of the electronic block.
The electronic block and the search coil are very sensitive towards sudden environmental
temperature alterations. When there is a sudden temperature change, the user should wait
usually 25-30 minutes before switching on the metal detector.
The inclusion of non air-conditioned and non tempered metal detector can cause its damage.
Signs of non tempering are: frustration, inability to regulate or evenness of the sound
threshold; a general lack of sound. In the presence of at least one of these signs, to prevent
injury, it is necessary metal detector immediately be power off and left off a few minutes to
temper and/or air conditioning (in high humidity, the transition from warm to cold and vice
versa).
While working with the metal detector, the search coil should be protected from damage (hit).
The usage of the metal detector in a rainy day may result in its damage.
The metal detector could be safely and properly used, if there is morning dew (because of the
watertight search coil). An extensive care should be taken, if the detector is put on the ground,
especially on a wet grass, as the water should not be allowed to get inside the electronic block
box and the power supply module box. The electronic block and the power supply module are
not watertight and a serious damage would be caused to the metal detector, if water gets
inside them.
If you are searching in areas, where ammunitions or other explosive substances may be
detected, be extremely careful when excavating, because we do not carry the responsibility for
your actions and behavior.
Do not open the electronic block box and the power supply module box. If this is necessary,
please contact us, using the contact information, given in 18, so that we could provide the
BLISSTOOL LTC48X -
User Guide (version EN201008241400)
Page 21 of 28
