BLiNQ Networks Inc.
X-1200 System Installation Guide
Release 1.0
Confidential - Restricted Use and Duplication
Page
35
Issue 01 D1
Figure 26 Ethernet Connector Assembly - Separated
2.
To properly pass the Ethernet cable and the RJ45 connector through the environmental housing:
Insert the RJ45 cable into the seal compression cover, the seal and then the gland body. See
Figure 26, “Ethernet Connector Assembly - Separated”.
3.
Assemble the connector by first ensuring that the seal is centrally aligned with the gland body and
then screwing on the seal compression cover.
Do not tighten yet!
You want the cable to still move
easily within the assembly.
4.
If needed, remove the cover/cap from the external RJ45 Ethernet connector/port located on the
underside of the module (if needed, see Figure 28, “Hub Module Showing All Connectors” on page
38).
5.
Plug the Ethernet cable into the external Ethernet RJ45 port on the module.
6.
Screw in the gland body assembly into the Ethernet RJ45 well on the module. Tighten the gland
body to the torque recommended in Table 12, “Recommended Torque Value for the RJ45 Ethernet
Connection”.
Seal Compression Cover
RJ45 Seal
Gland Body
Ethernet Cable
