BLAZE Instructional Book
Page | 30
Fuel (Gas) Conversion Instructions for BLAZE Gas Burners.
There will be an orifice conversion kit in each Side Burner appropriate for the opposite gas type. The kit
will include the office to be replaced.
CAUTION:
This should only by performed by a licensed gas professional.
Burners:
1.
You must remove the cooking grate to expose the main burner in the appliance.
2.
Pull up slightly on side burner head and rotate to the side. This will expose the orifice where the
gas enters into the burner. (pic below)
3.
Remove orifice and replace with orifice of desired gas type and reassemble.
4.
If unsure of full procedure please contact your dealer.
Troubleshooting
Smell of Gas is Present
Check for loose connections or cracks in the gas line. Perform a leak test
with soapy water or a leak testing solution.
DO NOT TRY AND TEST WITH
A FLAME.
If you find a leak, immediately shut off the gas supply and call a gas
professional to fix the problem.
Burner Does Not Ignite
Check position of
igniting pin.
It should jump over to the brass burner.
Clean area where contact will be made from spark tip to burner. Make sure
there is a blue spark at the electrode tip to burner. Make sure the wire is
connected correctly. Make sure the orifice is free of any grease or dirt.
Make sure burner
“
slit
”
is aligned with igniter.
ALWAYS TURN OFF GAS WHEN TESTING
Yellow Flame
Color on flame should be mostly blue. There should be a yellow tip
but if flame is completely yellow, clean burner and substances around
burner to remove oil or debris on the burner, burner pedestal or orifice.
Plugged Orifice
Remove orifice and clean with a fine wire.
No Gas To Burner
Check shut off valve to see if it is in the ON position – gas may be turned
off.
