BLAZE Instructional Book
Page | 22
ALL GAS CONNECTION POINTS SHOULD BE TESTED FOR LEAKS AFTER INSTALLATION
PRIOR TO FIRST USE OF THE GAS APPLIANCE(S).
Before installing an appliance in any island cut out, make sure that the opening is not bigger than the outside frame
of the appliance unit. The appliance should rest on the lip of the frame.
Pay careful attention to the location of the gas line. It should be routed away from sources of heat, sharp edges, and
aggressive surfaces and should make as few bends as possible.
Ensure the gas line connection will be accessible when appliance is installed. A safety shutoff valve is required at
this gas connection point.
The burner must be double checked for the correct placement in the appliance before operation. When finished
ensure that the burners are aligned in the bracket slot. Failure to do so could result in a fire and injury.
If the outdoor kitchen countertop will overhang the face of the island, notching out the two front countertop edges will
be necessary to allow the double burner to slide flush against the outer front wall to the outdoor kitchen. Due to
differing personal preferences of the size of the notch out, this is recommended to be done at the point of installation
so that the consumer can dictate their preference.
•
Slide the appliance into the cut out and then attach the gas line.
•
Be very careful not to kink the gas line when lowering the appliance into the cut out.
•
Keep your fingers away from where the appliance will be supported on counter. Your fingers could
become trapped and serious injury could occur.
