Page 24
If the main burner cotter pins are removed before installing, the main burners must be double checked for the
correct placement in the grill before operation. When finished ensure that the burners are aligned with the valve
orifice and seated in the bracket slot. This is accomplished by first placing the burner tube shutter hole securely
over the valve orifice and ensuring the male post on the rear of the burner rests in the corresponding slot in the grill
chassis. Failure to do so could result in a fire and injury.
If the outdoor kitchen countertop will overhang the face of the island, notching out the two front countertop edges will be
necessary to allow the grill to slide flush against the outer front wall to the outdoor kitchen. Due to differing personal
preferences of the size of the notch out, this is recommended to be done at the point of installation so that the consumer can
dictate their preference.
NOTE: The control panel of this unit is removable for service and must remain accessible. Do not seal around the
control panel preventing removal.
•
Slide the appliance into the cut out and then attach the gas line.
•
Be very careful not to kink the gas line when lowering the appliance into the cut out.
•
Keep your fingers away from where the appliance will be supported on counter. Your fingers could become
trapped and serious injury could occur.
•
Check to make sure the appliance is level and is supported around the entire outside edge. If the appliance is
not level or is unstable, use non-combustible shims under the outside lip to stabilize it.
Perform the leak test procedure as described earlier in this manual.
*Ensure your island cavity is adequately vented. Number of vents shown in diagram is for
informational purposes only. Consult your local licensed professional for adequate requirements.
*Ensure your outdoor kitchen is constructed out of non-combustible materials.
Summary of Contents for BLZ-3LBMLP
Page 34: ...Page 34 ...
