OM-SC25 E V1.04
July 11, 2016
Page 41
SC25
MAINTENANCE cont.
LOADING DOOR TENSION ADJUSTMENT
1. Lift the outer shroud up and off of magnets
and top screws.
2. Open the door.
3. To tighten the door tension use a 7/16”
wrench to loosen the two nuts on the latch
cover. Slide the latch cover towards the back
of the appliance and tighten nuts.(
Fig. 22
)
Repeat paper test (see “LOADING DOOR
GASKET INSPECTION” on page 37).
Fig. 22
LOADING DOOR HINGE ADJUSTMENT
1. Open the door to 90°.
2. Hold bottom nuts using a 9/16” wrench. Use
a 1/4” Allen head screwdriver to back nuts
off the bolts. (
Fig. 23
)
3. Remove the door by lift ing up and out.
Fig. 23
DO NOT OPERATE THIS WOOD APPLIANCE IF
THE DOOR GASKET IS MISSING OR DAMAGED.
DANGEROUS OVER FIRING CAN OCCUR
WHICH CAN DAMAGE THE APPLIANCE OR
IGNITE CREOSOTE IN THE CHIMNEY, POSSIBLY
CAUSING A HOUSE FIRE. IF ANY PART OF
THE WOODAPPLIANCE OR FLUE SYSTEM IS
GLOWING THE APPLIANCE IS BEING OVER
FIRED.
NOTE: YOUR DOOR WAS SET AT THE FACTORY,
DO NOT ADJUST UNLESS NECESSARY
