PAGE 30
OM-9603
Revision Date: 12/15/04
Date Printed: Tuesday, February 08, 2005
STARTING THE STOVE FOR THE FIRST TIME
♦
Fumes and smoke may come from your stove. This is perfectly normal, and is a result from the paint and
oily residue curing and burning off on different parts of the stove. Blaze King burns each stove at the factory
prior to shipment, but there may be areas that are not fully cured. It is suggested that the stove be left
burning with the fans off for a period of 2-3 hours and that the building be properly vented during the
process.
♦
Condensation usually will appear on the inside of the glass when the stove is turned on. This is a normal
reaction, and will clear up shortly.
♦
Blue Flames will burn initially until the stove warms up a bit, and then they should turn more yellow.
The optional Accu-Temp
Remote Control Thermostat
can be used for wireless
control of the stove. The
manual switch
must
be in
the off position.
Hand Held 1000
72
ACCU-TEMP
TM
TURNING THE STOVE ON AND OFF
After the pilot has been established...
Stove On / Off Switch
Use this switch to turn the
stove on and off manually.
Robert Shaw
One of the two Millivolt Thermostats on the right
come standard with every Direct Vent. It mounts
on the wall and is wired directly to the stove valve.
The manual switch
must
be in the off position.
NOTE: If using any one of the thermostat controls, the manual switch must
be in the OFF position. If it is left ON the stove will continue to run and the
thermostats will have NO control over the stove.
WhiteRogers
ACCU-TEMP
Model 1000
WIRELESS REMOTE CONTROL
THERMOSTAT KIT.
OPTIONAL EQUIPMENT
RECEIVER
TRANSMITTER
ADJUSTING THE FLAME HEIGHT
To adjust the height of the flame , simply turn the silver HI/
LO knob (Pressure Regulator) located on the valve (page
27). Turn the knob clockwise to increase flame height, and
counter clockwise to decrease.
ADJUSTING BLOWER SPEED
Your stove comes standard equipped with a Dual Squirrel Cage Fan. This fan helps distribute the heat
produced by the stove. The fan will automatically come on within approximately 10 minutes after the stove has
been turned on, and will continue to run until the stove has cycled off and cooled down.
This is the Rheostat Knob, it controls
the fan speed. The fan cannot be
fully turned off, as it would lower the
efficiency of the unit.
