PAGE 10
OM-9603
Revision Date: 12/15/04
Date Printed: Tuesday, February 08, 2005
UNIT MUST BE LAGGED TO FLOOR .
A separate ground wire must be grounded from unit to frame of mobile home. Use a copper lug w/tab and
attach to hole in the right rear of pedestal.
A manufactured home (mobile home) installation must conform with the Manufactured Home construction and
Safety Standard, Title 24 CFR, Part 3280, or, when such a standard is not applicable, the Standard for
Manufactured Home Installations, ANSI A225.1/NFPA 501A.
MOBILE HOME INSTALLATION
As you plan your installation consider the following:
The stove should be placed as central in the home as possible. Consider safety, convenience, traffic flow and
the fact that the stove will need a venting system.
DUE TO HIGH TEMPERATURE THE ROOM HEATER SHOULD BE LOCATED OUT OF TRAFFIC AND AWAY
FROM FURNITURE AND DRAPERIES. MINIMUM CLEARANCES SHOWN ON PAGES 23-24 ARE TO
PREVENT WALLS AND CEILINGS FROM CATCHING ON FIRE.
For the type of vent system to be used, see pages 12- 20. Electrical Power is 115-60HZ SEE PAGE 31 FOR
TERMINATION CHART
WARNING
ONLY PERSONS LICENSED TO WORK WITH GAS PIPING MAY MAKE THE NECESSARY GAS
CONNECTION TO THIS APPLIANCE. BE SURE GAS PLUMBING INSTRUCTIONS AND ALL STATE AND
LOCAL CODES ARE CAREFULLY FOLLOWED. USE APPROVED FLEXIBLE GAS CONNECTIONS OR
RIDGED PIPING DEPENDING ON STATE OR PROVINCIAL AND LOCAL CODES TO ATTACH BURNER TO
GAS SUPPLY. BE SURE TO USE PROPER SIZE GAS SUPPLY LINE. CAREFULLY CHECK ALL
CONNECTION FOR GAS LEAKS WITH SOAP AND WATER SOLUTION.
NOTE: DO NOT CHECK FOR LEAKS USING AN OPEN FLAME.
EACH INSTALLATION MUST CONFORM TO ALL STATE, PROVINCIAL, LOCAL AND NATIONAL CODES.
REFER TO THE NATIONAL FUEL GAS CODE AND LOCAL ZONING AND CODE AUTHORITIES FOR
DETAILS ON INSTALLATION REQUIREMENTS. THE BLAZE KING APPLIANCES MUST BE VENTED TO
THE OUTSIDE IN ACCORDANCE WITH THE LATEST EDITION OF THE NATIONAL FUEL GAS CODE. IN
THE ABSENCE OF LOCAL CODES, THE INSTALLATION MUST CONFORM WITH NATIONAL FUEL GAS
CODE ANSI Z223.1 ALSO KNOWN AS NFPA 54.
PLANNING YOUR STOVE PLACEMENT
WARNING - The appliance, when installed must be electrically grounded in accordance with
local codes or in the absence of local codes with the National Electrical Code ANSI/NFPA 70-
1987. Or the current Canadian Electrical Code - CSA.C22.1
ELECTRICAL GROUNDING INSTRUCTIONS
The power cord that comes with the unit will have a Green wire with ring (eye) connector on the end of it.
This has to be attached to a green screw located on the bottom of the right of where the fan assembly rests.
CLEANING YOUR PEGASUS 9603
Your appliance was designed with very low maintenance in mind. At the end of the heating season
simply turn the control knob on the gas valve to the “OFF” position. Allow the unit to cool off completely, then
vacuum all accessible portions of the unit, including inside of the fire box. (Remove logs and embers first, then
place back into position.)
NOTE: THERE ARE NO PARTS THAT REQUIRE LUBRICATION ON THIS STOVE
