11
DEUTSCH
ENGLISH
FRANÇAIS
IT
ALIANO
NEDERLANDS
SVENSKA
ESP
AÑOL
PORTUGUÊS
1
POWER INPUT TERMINAL (RED)
To be connected to the positive termi-
nal of your vehicle battery or other
co12V source.
2
REMOTE SWITCH-ON INPUT
TERMINAL (ORANGE)
To be connected to the remote control
cable or antenna lead of the source
unit for remote ON/OFF.
3
GROUND INPUT TERMINAL
(BLACK)
To be wired to the vehicle’s chassis
ground.
4
POWER INDICATOR
This indicator lights up when the inter-
nal switching current supply is acti-
vated and the unit is operational.
5
LEFT/RIGHT FRONT CHANNEL
SIGNAL INPUTS
To be connected to the front channel
output of the source unit.
6
PARALLEL INPUT SWITCH
“IN”: When the parallel input is in the
“IN” position, the input signals coming
in through the front channel signal in-
puts are split and directed to the front
and rear channels simultaneously.
(This feature is to be engaged when
the source unit has no separate front,
rear or subwoofer channel outputs.)
“OUT”: If the source unit has inde-
pendent front and rear channel out-
puts, disengage the parallel input by
sliding the switch to the “OUT” posi-
tion.
7
LEFT/RIGHT REAR CHANNEL
SIGNAL INPUTS
To be connected to the front and rear
channel output of the source unit, BUT
MAKE SURE THAT THE INPUT
SWITCH IS IN THE “OUT” POSITION.
CONTROLS, INDICATORS, AND TERMINALS
8
LEFT/RIGHT MIXED IN/OUT
TERMINALS
As input terminal: to be connected to
the source unit.
As output terminal: to be connected to
the front channel input terminal of an-
other electronic crossover in a multi-
crossover system.
9
FRONT CHANNEL HIGH-PASS
FREQUENCY SELECTOR
For selection of front channel high-
pass crossover frequency between
32 Hz and 400 Hz (or 640 Hz and
8 kHz when its frequency multiplier is
in the “x20” position.)
:
REAR CHANNEL HIGH-PASS
FREQUENCY SELECTOR
For selection of front channel high-
pass crossover frequency between
32 Hz and 400 Hz.
;
FRONT CHANNEL HIGH-PASS
FREQUENCY MULTIPLIER
Positioning this switch in the “x20” po-
sition changes the range of selectable
crossover frequencies for the front
channel high-pass from 32 Hz - 400
Hz to 640 Hz - 8 kHz.
<
SUBWOOFER FREQUENCY
SELECTOR
For selection of the low-pass crosso-
ver frequency for the subwoofer chan-
nel between 32 Hz and 400 Hz.
=
BASS BOOST SWITCH
When activated, this circuit provides a
single octave boost of 12 dB at 45 Hz
to compensate the woofer enclosure.
>
PHASE INVERTER
Positioning the switch in the “180” Po-
sition shifts the subwoofer output sig-
nals 180 degrees out-of-phase rela-
tive to the front and rear output sig-
nals.
