ENGLISH
E-15
Specifications
GENERAL
Dimensions
:
Approx. 178 mm
×
50 mm
×
155 mm
(W
×
H
×
D) *excluding Front panel.
Power requirements
:
12 volts DC car battery
(negative ground)
Output Power
:
RMS and Peak Power ratings
(188watts)
220 watts /55 peak
×
4 ch
Output
Wiring
:
F
loating-ground type designed for 4
speaker use.
RCA low-level outputs (2 channels).
Output Impedance
:
Compatible with 4-8 ohm speakers.
Low - Level Output
:
2
V
.
TUNER
T
uning Range
:
A
M
:
530 - 1,710 kHz (10 kHz step)
F
M
:
87.5 - 107.9 MHz (200 kHz step)
Sensitivity
:
A
M
:
20 μV
FM
:
9.1 dBf mono sensitivity
FM
Stereo Separation
:
35 dB
CD P
L
A
YER
Frequency
Response
:
20 - 20,000 Hz
S/N Ratio
:
98 dB
W
ow & Flutter
:
Below the measurable limit
OTHER
Remote Control options
:
RC-823 Credit Card Remote
CD Changer cable
:
p/n F00E500029
AUX input cable
:
p/n 7 607 897 093
T
roubleshooting Guide
The following check will assist in the correction of most prob-
lems which you may encounter with your unit. Before going
through the check list below
, refer back to the connection and
operating procedures.
General
Radio reception
Also make sure that antenna is connected, extended and dry
inside.
If the above mentioned solutions do not help to improve the
situation, consult your nearest
Blaupunkt
dealer or in the
United States call 1-800-266-2528 for technical assistance,
parts and service. Call 1-800-950-2528 for dealer referral or
to request product brochure.
Cause/Solution
Leads are not matched
correctly with the car
’s
accessory power
connector
.
Check wiring for short
circuits.
The car doesn't have an
ACC position.
T
rouble
•
Memorized stations and
correct time are erased.
•
The fuse has blown.
•
Radio works when the igni-
tion key is the ON,
ACC and
OFF positions.
•
No power is being supplied
to the unit.
•
The power is continuously
supplied to the unit.
T
rouble
Preset stations are not re-
ceivable.
Seek tuning is not possible
T
ravel Store feature does
not complete storing of six
stations.
Cause/Solution
The broadcast signal is too
weak.
The broadcast signal is too
weak.
→
Use manual tuning.
Not enough broadcast frequen-
cies are receivable.
CD Player T
roubleshooting
When problems occur with CD playback, an error message
appears in the display window
.
Refer to the table below to identify the problem, then take the
suggested corrective action. If the error persists, contact your
nearest
Blaupunkt
dealer
.
Message
Possible cause
Recommended action
FOCUS
ERR
Dirty disc.
Scrached disc.
Up-side-down.
Clean the disc.
Replace the disc.
Check the disc.
SER
VO
ERR
MECHA
ERR
Mchanical problem.
Eject and re-insert.
T
OC ERR
The disc cannot
read properly
.
DA
T
A
TRACK
Plays the data track
of MIX mode CD or
CD-ROM.
CD Changer T
roubleshooting
When problems should develop while operating CD changer
,
an error message appears in the display window
.
Refer to the table below to identify the problem, then take the
suggested corrective action. If the error persists or “MECHA
ERR” and “09 ERROR” appears, contact your nearest
Blaupunkt
dealer
.
Message
Possible cause
Recommended action
NO MAG
NO DISC
No magazine.
No disc.
Load the magazine in
the CD changer
.
Check the disc.
CD ERR
Up-side-down.
Focus error
.
Check the disc.
COMM ERR
Communication error
.Check the connection of
the CD changer
.
TEMP ERR
Excessive tempera-
ture conditions at
the CD changer
.
Eject and re-insert. In-
sert anothert disc.
The error sign will go of
f
and play will resume
when the temperature to
a normal range.
Data and focus error.
Eject and re-insert.
Y
ou can not play a CD-
ROM. Skip the music
track with
TUN/TRK dial.
