9
3.
Hook the Control Panel onto the plate, then slide the control panel left to secure the panel and
depress the tamper switch against the mounting plate. (
Figures 4
)
Figures 4
PIR Sensor
The PIR Sensor has knockouts on the back where plastic is thinner. The 2 central knockouts are
for flat wall mounting, and the four side knockouts are for corner mounting. (
Figure 1
)
1.
Break through the knockouts, use the knockouts to mark position on wall or corner. (
Figure 2
)
Figure 1 Figures 2
Wall Corner
2.
Drill holes into the wall or corner using the knockouts as template, insert wall plug if required.
(
Figure 3
)
3.
Screw the PIR Sensor base onto the wall or corner at marked location. (
Figure 4
) Then replace
the PIR Sensor cover onto the base.
Figure 3 Figure 4
Wall Corner Wall Corner
Corner Fixing
Knockouts x 4
Surface Fixing
Knockouts x 2
(Inside)
Summary of Contents for SA 2700
Page 1: ...SA 2700 Kit User Manual ...
Page 3: ......
