2
Accessories
Door Contact
The Door Contact is mounted on the Door or Window frame to detect door/window opening. When
triggered, it will transmit a signal to Control Panel to alert the condition
LED Indicator:
The LED will light up if the Door Contact is triggered under
tamper open or low battery status to signal fault.
Learn / Test Button:
The Learn / Test button is used to send signal for learning
Door Contact or test range.
Tamper Switch:
The tamper switch is compressed against door or window
frame when installed. When the Door Contact is removed
from installed location, or its cover opened, the Tamper
Switch will be activated.
Rib Mark:
The Rib Mark marks the location of the Door Contact
’s
internal magnetic switch to help alignment with the magnet.
Magnet
The magnet is mounted on the door and window and should align with the Rib mark when
installed.
PIR Sensor
The PIR Sensor raises alarm upon detecting intruder.
Parts Identification:
LED Indicator & Learn & Test Button:
The LED will light up if the PIR Camera detects movement under
tamper open or low battery status to signal fault.
PIR Sensor:
The PIR Sensor has a detection coverage of about 110
°
to the
front.
IMPORTANT NOTE:
The Battery Switch is set to
OFF
by factory default. Please make sure to turn the switch to
ON
after connecting AC power to the Control Panel, otherwise the battery will not be charged and
the Control Panel will be without back up power when power fails.
It takes about
72
hours to fully charge the battery. When fully charged, the battery can serve as
back-up power source for about
15
hours.
LED Indicator&
Learn/Test Button
PIR Sensor
Magnet
LED
Indicator
Learn/Test
Button
Rib Mark
All accessories included in the kit content are pre-linked with Control Panel and do not require
manual linking (learning). If learning is required, please refer to the the server user manual.
Tamper
Switch
