Blaupunkt MC80BT, Owner'S Manual

Page: 12 / 81

10
3. Please check if the power source is correspond to the rating voltage spec which locates on
the back panel of main unit. If it does not matching, please consult to your dealer or
service center.
4. Insert the attached AC power plug into the wall outlet in order to get the power. The front
panel power LED will light on in red color when the power is ready.
Remote control battery installation
Open up the battery door and insert 2 x AAA battery into the compartment; please
make sure the polarity of battery will aim and correspond to the positive and
negative engraved symbol in the compartment. Then close the battery door.
Notes:
a. The best working distance of remote control is within 7 meters without any obstacle in
between. Please aim to the remote control sensor locates on the left corner of display
during operation.
b. The sensitivity of remote control will become weak when the battery power exhausted.
Please replace it with fresh one for operation.
c. Please take out the battery in case of none-operation in a long time.
d. Please dispose the battery in a environment friendly way. Please reference the local
government requirement for the detail.
General operation
1.
Power on/off and standby: Press the power on/off switch on rear panel to ON position to
power on the unit after connect the AC power successfully; Press the power button on
front panel or remote control for standby on and off switching. Press the please remove
the AC plug for complete power off.
2. Mute: press the MUTE button on remote control to silence the sound output; press it
again to resume the playing. You can also resume the playing by press the /-
button.
3. Source/mode, CD/USB: press the SOURCE button repeatedly to switch the play mode
between CD-FM radio- Line in- Bluetooth. You also can enter to the Bluetooth mode
directly by press the BT button from remote control.The USB playback mode is only
available when the USB stick has plugged intothe USB port, press the CD/USB button enter
to USB mode; or in CD mode, the unit will play the USB automatically after few seconds if
there is no CD loaded inside.
You also can press the mode button repeatedly on front panel to switch the play source.
4. Volume adjustment: press the VOL+/- button to increase or decrease the output volume,
or turn the volume knob on the front panel.
5. Treble & bass adjustment: press the /- and BASS +/- button from remote control
for the treble and bass adjustment; or press the tone button first, then turn the tone +/-
knob on front panel for adjustment.
MC80BT