Blaupunkt HSA701BK, Owner'S Manual

Page: 8 / 84

5
1. Travel protective cover
2. Curling chamber
3. Cylinder with tourmaline coating
4. Rotating hook
5. LCD
6. Curling button
7. Timer adjustment button
8. Temperature adjustment button
9. On/Off switch with curling direction option
10. Swivel power cord
11. Accessory for cleaning
WORKING PARAMETERS OF THE AUTOMATIC CURLER
1. The time of a single cycle
Range: 5-12 seconds
The default setting is 5 seconds. To change the time, press the timer button (7).
Select a shorter time winding to effect of gentle wave or longer for a stronger curls.
2. Temperature adjustment
Range: 140-230 ℃
The default setting is 190
℃
. To change the temperature, press temperature adjustment button
(8).
Select a lower temperature of the winding to effect gentle undulations or higher for stronger
curls.
NOTE: The lower temperature is recommended for fine and dyed hair. Higher temperature is
recommended for thicker hair or naturally wavy.
3. Direction of curling
There are three settings available: left, right, and automatic. Auto mode selects alternately turn
direction once to the right, once to the left.
Select the operating mode with the switch (9).
HAIR PREPARATION
Make sure the hair is clean, well-combed and dry. Seperate the sections of hair not wider than 2cm.
USING THE AUTOMATIC CURLER
1. Connect the device to a power source.
2. Set the curler as described in section WORKING PARAMETERS OF THE AUTOMATIC CURLER.
3. Wait until the curler beeps to indicate readiness.
4. Insert the strand of hair into curling chamber (2) so that hair goes under rotating hook (4) as
shown on figure No. 2.
5. Press curling button (6).
6. The curler winds the hair around the cylinder and holds for the amount of time set. Then it
releases the hair.
7. Repeat steps 4 - 6.
8. After finished usage of the curler, turn off the switch (9) and unplug the power cord.
NOTE: After 60minutes, curler turns off automatically. To resume operation, turn off the switch
(9) and restart.
It is recommended not to comb hair just after finished curling. When the hair cools down, the
effect will be stronger.
WHEN HAIR GETS TANGLED
If the curler is used as advised and hair is combed through, it should not happen that hair is drawn in
and tangled. It is important that hair section is not too big and comb runs easily through hair.
The curler automatically monitors the operation of winding engine. In case hair gets improperly drawn
in, the device will give three short beep signals and start to curl in the opposite direction in order to
release hair.
HSA701