46
LOUDNESS Loudness boosts the bass
frequencies at low volume.
LOUD 1 - Low boost
LOUD 6 - Max. boost
BAS CENT
Bass Center Frequency Ad-
justment.
Adjusts the mid-range fre-
quency to the specific
equipment in the vehicle
(50 or 100 Hz)
TA VOL
The traffic announcement
and warning beep volume
can be set between 0 to 63.
The message will then
come through at this volu-
me, if the standard volume
is lower.If the standard vo-
lume is set higher than the
TA VOL level, then the traf-
fic report will be played at
the standard volume.
REG OFF
To listen to a regional radio
programme outside of its
RDS transmission range,
switch on "REG ON".
For full RDS service, switch
to "REG OFF".
SENS LO
Adjusts seek tuning
sensitivity."LO" stands for
local reception."DX" stands
for distant reception.
Select "LO 3" if you want to
receive strong stations in
the local area, select "DX
1" if you want to tune into
weaker stations which are
further away.
CDC NAME Names CDs .A maximum of
99 CDs can be given na-
mes of up to 7 characters.
CLOCK 24
Switches between 12-h and
24-h clock display.
CLOCKSET Sets the clock manually.
Press << >> to select
hours/minutes. Press /
to adjust the flashing value.
TIMER
Switches on a selected ra-
dio station at a selected
time.
ON VOL
Sets the turn-on volume.
Press << >> to adjust the
turn-on volume as desired.
MUTE
Changes the mute volume.
BEEP
Changes the volume of the
acknowledgement tone
(beep) between 0 and 9.
(0 = off)
DSC programming
The car radio has been equipped with DSC
(Direct Software Control) to allow you to cu-
stomise certain programmable, basic set-
tings to suit your personal needs and pre-
ferences and then store them.
The basic settings for this audio equipment
were made at the factory.
In the following you can find an overview of
these settings, so that you can always re-
set to them if desired.
If you wish to alter any of the programming,
•
press DSC.
MENU / will light up in the display.
Use the / buttons on the rocker switch
to select the functions you wish to change.
The display will show you the setting you
have selected. Press << >> on the rocker
switch to change the values. Confirm the
setting you have selected by pressing the
DSC button.
/
Select function
<< >> Adjust/recall value
St.TropRavLasVegasDJ gb
22.03.2001, 16:11 Uhr
46
