29
Atlanta RD 105
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Important notes
What you really have to read
Before you operate your new car radio, plea-
se read the following information carefully.
Traffic safety
As the driver of a motor vehicle, it is your
responsibility to pay attention to the traffic
situation at all times. Never use your car radio
in a way that could distract you.
Please keep in mind that you travel a di-
stance of 14 m per second at a speed of only
50 km/h.
Do not adjust your radio in difficult driving
conditions that demand your full attention.
Always make sure that you are still able to
hear any warning signals coming from outsi-
de of the vehicle, such as police or fire engine
sirens, so that you can react accordingly.
Installation/connection
In order to ensure that the set functions
properly it is necessary that the positive po-
wer supply line is connected to the ignition
and to the per12 V connector of the
car radio.
If you would like to install your new car radio
by yourself or add other audio components to
the existing ones, then please read carefully
the enclosed instructions on installation and
connection.
Do not connect the loudspeaker outputs to
ground!
Use only the accessory and replacement
parts approved by Blaupunkt.
Optical indication of theft protec-
tion
When the car is stationary, you can let the
KeyCard tongue flash in order to indicate that
the set is equipped with security coding. Use
DSC to select one of two settings: LED ON or
LED OFF.
For more information, please read through
chapter “DSC programming - LED ON/OFF”.
KeyCard
The car radio can only be operated using
either KeyCard 1 or 2. Their codes are stored
in the unit.
Turn on the set and introduce the KeyCard
completely. The car radio is now ready for
operation. When inserting a wrong KeyCard,
the display will show “----”.
After approximately 10 seconds, “CARD
ERR” will appear in the display. In this case
do not make any further adjustments until
you have the corresponding KeyCard availa-
ble.
Never try to pull out the KeyCard by force.
First, slightly press the card in. This releases
the KeyCard; the display shows
“LEARNING”. Now you can pull out the card.
Should the KeyCard be lost or damaged,
then please contact one of our authorised
service partners to get a new card.
The service centres are marked ( ) in the car
radio service centre list. In case of doubt,
please contact the central service centre in
your country for more information on the
KeyCard service centre closest to you.
Use either KeyCard (1 and 2) to individually
store the following functions as desired:
bass, treble, balance and fader settings, pre-
set stations, loudness, TA (traffic announce-
ment volume), SPEECH (tone control for
speech programs), BEEP volume, SCANTI-
ME, VOLFIX.
In addition to this, the settings activated be-
fore switching the radio off, such as the
waveband, station, TA priority, loudness, AF,
REG ON/OFF or seek tuning sensitivity will
also remain stored.
When you insert your KeyCard, the basic
settings you have programmed will automa-
tically be activated.
