background image

GB

OPERATION

A

C

B

D

E

F

With the hood switched off, p ressing a ny k ey w ill a ctivate t he c ontrol p anel i n s tand-by m ode. T he 
symbols are backlit by a white light, allowing you view and select the desired function.
Pressing one of the keys again will start the corresponding function, and its symbol will light up. After all 
functions have been switched off, the control panel will remain in stand-by mode for around 30 seconds 
and then switch off automatically.

A: 

Light ON/OFF key: press this touch sensor to switch on or off the lights of the hood.

C:

 Motor ON/OFF key (4 speed): press this touch sensor to switch on the hood extractor fan at the same 

speed as it was when last switched off. Use the „D“ and „B“ keys to vary the speed (power) of extraction.

B: 

Decrease extraction speed (power) key: press this touch sensor to reduce the extraction speed of the 

hood.

D: 

Increase extraction speed (power) key: press this touch sensor to increase the extraction speed of the 

hood.

E: 

Timer key: when this touch sensor is pressed, independently of the extraction speed selected, the 

timer function will be activated. Press once to set the timer for 5 minutes, press a second time for 10 
minutes and a third time for 20 minutes. During this phase, the „E“ symbol will flash.
To reset the timer, press the motor key, „C“

F: 

Reset filters key: press this touch sensor to reset the signal that warns that the metal grease filter (1) 

is saturated and the charcoal filter (2) should be replaced. (1) After 40 hours of using the hood, the „F“ 
symbol will flash to indicate the necessity of cleaning the metal grease filters.
(2)

 

After 120 hours of using the hood, the „F“ symbol will light up to indicate the necessity of replacing

 

the activated charcoal filters. 

Sensor function:

 pressing the „B“ and „D“ keys at the same time will activate the sensor. In this mode the 

extraction speed sets itself automatically and the „B+D“ key flashes intermittently. To return to manual 
operation, press either the „B“ or the „D“ key.

Note: 4 hours after the last key touch, the fan will automatically turn off.

All hoods with capacities exceeding 650 m3/h have the last timed speed; It lasts for 7 minutes, after 
which it automatically returns to the last non-timed speed.

6

Summary of Contents for 5DB69253AU











Reviews: