Blaupunkt 368417, Owner'S Manual, Page: 5 / 12

4
STEP 3 STEP 2
INSTRUCTIONS FOR USE
The air cooler is designed to be operated using a USB power source. It can be used with or without
water, but for optimum cooling it is recommended to fill the air cooler water tanks with water
following the instructions below.
The air cooler must be switched off and unplugged from the power supply before filling the water
tanks.
STEP 1: Open the water tank access doors and pull the water tanks up and away from the air cooler.
STEP 2: Remove the filter block by lifting and sliding it sideways out of the air cooler and run it under a
steady stream of cool, clean water so that the filter becomes fully wet. Shake gently to remove the
excess and replace the filter block into the air cooler.
STEP 3: Remove the water tanks, unscrew the caps and fill them to the brim with cool, clean water.
Replace the caps and slide the water tanks back into position so that they are seated properly. The
valves in the caps should begin to release the water into the air cooler. This will fill the reservoir in the
base of the air cooler main unit with water.
STEP 4: Carefully close the water tank access doors.
Note: For additional cooling, the water tanks can be filled to the indicated line and placed upright into
the freezer for 8 hours. When the tanks have fully frozen, they can be topped up to the brim with cool,
clean water and then inserted into the air cooler following the instructions in the section entitled ‘Filling
the Ice Cube Plus Personal Space Cooler’.
The wet filter block can be placed in the freezer with the water tanks for 8 hours until frozen to increase
the cooling effect.
Do not freeze the water tanks with the caps on – this could cause damage to the valves and to the
water tanks.
Caution: Do not fill the air cooler with any liquid other than cool, clean water. Do not use any additives
in the water.
Filling the Ice Cube Air Cooler