www.blaubergventilatoren.de
9
VENTO Ergo A50/50-1 Pro
5.
Install the ceramic heat exchanger with both filters, front and back, and the air flow rectifier, fig. 11.
6.
Install the ventilation unit on the mounting plate, by simple pressing until it is fixed by magnets , fig. 12.
7.
Mark the fastening holes for the outer ventilation hood:
•
Fig. 13a - models VENTO Ergo A50 Pro and VENTO Ergo A50-1 Pro;
•
Fig. 13b - models VENTO Ergo A50 S Pro and VENTO Ergo A50-1 S Pro. Mark the holes with the master plate from the delivery set.
Drill 40 mm deep holes for the dowel 6x40.
8.
Insert the dowels 6x40 from the delivery set into the holes.
9.
Disassemble the outer ventilation hood to enable access to the fastening holes:
•
Fig. 14a - models VENTO Ergo A50 Pro and VENTO Ergo A50-1 Pro. Remove the upper part of the outer ventilation hood.
•
Fig. 14b - models VENTO Ergo A50 S Pro and VENTO Ergo A50-1 S Pro. Loosen 5 screws and take off the upper part of the outer ventilation hood.
Fig. 11. Unit components mounting
Fig. 13a
Fig. 14a
Fig. 14b
Fig. 13b
Fig. 12. Ventilation unit mounting
193,5
Ø6
4 holes
246,4
220
Ø6
4 holes
220
1
2
