12
www.blaubergventilatoren.de
KOMFORT EC LW
The room temperature sensor is integrated into the control panel, for that
reason the control panel must be installed in a temperature balanced place,
at least 1 m away from the heating equipment, doors and windows. Fix the
control panel to the wall using the screws and connect it to the air handling
unit using a supplied ten-wire connecting cable. The control panel is supplied
assembled and pre-wired to the unit. In case of need to re-assemble the
control panel follow the steps below.
Unit mounting sequence:
1. Install a small screwdriver with a 3.5 mm slot width in one of the
rectangular control panel openings for 4 mm.
2. Press the screwdriver to open the control panel.
3. Route the required cables and wires and install a junction box (included
in the delivery set) in the wall.
4. Connect and place the executive element inside of the mounting box.
5. Fix the back side of the control panel to the wall using screws.
6. Connect the executive element to the front part of the control panel
and install the front panel.
WARNING
For correct operation of the unit place the control panel in the premises, ventilated by this unit.
Do not lay the cable in close proximity parallel to the control panel cable!
Do not coil the control panel cable in loops while laying it.
!
AUTO
ROOM
90
90
63
63
4
4 отв.
90х90х18 мм
61х61х39 мм
Fig. 12. Overall dimensions of the control panel
KOMFORT_EC_LW_v1(5)_EN.indd 12
07.09.2015 13:06:23
