www.blaubergventilatoren.de
Freshbox 100
14
7. Viewing the temperature sensor readings.
To enter the Sensor Readings View mode, turn the unit off. Then press
and
on the control panel simultaneously and hold them
down at least for 3 seconds.
The indicators
SET
and light up in the Sensor Readings View mode.
• To view the current temperature sensor readings, press and hold
.
• Press
to view the controller board model code and software version code on the
control panel display.
• To exit the Sensor Adjustment mode, press
.
8. Filter replacement indication.
On the expiry of filter service life (3 000 hours) the operating mode temperature normally shown on the control panel display is
replaced by indicating the need to replace the filters.
• When the filter replacement indicator is active, switch off the unit by pressing
and disconnect it from power supply. Then replace the filters (see the sequence in the
«Technical Maintenance» section).
• Then switch on the unit by pressing
on the control panel or
on the remote
control. Then press
and
simultaneously to reset the hour meter.
9. Date/time setting.
• Turn the unit off.
• To enter the Date/Time Setting mode press and hold
. Then press
on the control panel.
• While holding down
select the parameter for adjustment by pressing
and
. The adjusted parameter is blinking.
The date/time setting parameters are arranged in the following order:
1. Minute
2. Hour
3. Day of the week
4. Date
5. Month
6. Year
• Set the desired value of the selected parameter by pressing
and
on the control panel.
• To exit
Date/Time Setting mode, press
.
10. Scheduled Operation mode.
• Press and hold
, then press
on the control panel to activate the Scheduled Operation mode. The indicator
lights up when
the Scheduled Operation mode is activated.
• Press and hold
, then press
on the control panel to deactivate the Scheduled Operation mode.
• From the remote control the Scheduled Operation mode is activated/deactivated by pressing
.
• Timer control has higher priority than scheduled operation.
