Blastrac BMS-H2750, Operating Manual

Page: 13 / 28

12
SECTION V
BMS-H2750
START-UP AND BREAK-IN
The BMS-H2750 has been safety tested and run at our factory prior to shipping. All fluid levels
have been topped off; however, no propane has been added to the tanks for safety shipment
purposes. Before running the
BMS-H2750 please check the following items that may have shifted
or changed during shipping.
1. Raise engine covers and check oil level.
2. Check air cleaner filter element for snug fit.
3. All battery cable connections are snug.
4. Inspect for major hydraulic oil leaks. Snug hydraulic fittings using two wrenches. Use
caution not to over tighten.
5. Fill propane tank.
6. Mount propane bottle in brackets, be sure bracket alignment pin corresponds with
alignment slot on bottle.
7. Attach propane hose to liquid side of bottle by attaching to the handle valve. Snug fit the
female connector attached to hose and slowly turn valve on. You should hear gas briefly
enter the propane hose. Immediately check for propane leaks with soapy water solution. If
leak persists after retightening the knurled female connector:
STOP , turn off the bottle at
valve and seek assistance from certified propane professional. Serious damage and or an
explosion could occur.
8. Check lug bolts for tightness, torque 85-100 lbs.
9. Return all engine guards to proper position.
10. You are now ready to start the engine.
11. Crank the engine by turning the key in the on position. The engine will crank for 3 to 5
seconds while the propane enter the carburetor. If the engine does not start, turn the key
off, wait 1 minute and try again. If again unsuccessful, check propane valve to be sure it is
open. If still unsuccessful turn off propane valve and seek assistance or call 1-800-256-
3440.
12. Once the engine is warming and running, and the operator is safely in the seat, the machine
can be driven.
Please turn to Section VI for Machinery Operation.
NEW MACHINE BREAK-IN
Since the
BMS-H2750 is a very low maintenance and user-friendly machine, the only break-in is
for the Kohler engine. Please refer to the owners manual, included is the manual and the
maintenance schedule found inside the air cleaner plastic cover supplied
by Kohler.