MODEL 1-8DEZ BLASTER
OPERATING MANUAL
SECTION 2
SAFETY PRECAUTIONS
JUNE 2007
A thorough understanding of your 1-8DEZ will help ensure that it can be operated
efficiently and with minimized safety risks. No instructions, written or verbal, can
be effective without the use of sound judgment and good work practices in the
operation and maintenance of the 1-8DEZ. The U.S. Department of Labor
Occupational Safety & Health Administration (OSHA) provides standards and
regulations relating to the use of portable tools on construction sites. The
operator of this 1-8DEZ should be familiar with, and understand these
Regulations and Standards. These Standards and Regulations are posted on the
OSHA Website at www.osha.gov.
CAUTION: Always keep the abrasive valve control lever in
the off/closed position except when the 1-8 is actually blast
cleaning. Immediately close the abrasive control valve by
releasing the handle-mounted shot valve control if you
experience any irregular or hazardous situations while
operating or maintaining the 1-8DEZ. Unusual situations
include, but are not limited to, loud noise and excessive
vibration.
Before actual shot-blasting can begin, the operator should be certain that the
1-8DEZ will clear all obstructions in the work area. Work areas must be dry and
clean (no loose debris) before cleaning can begin
.
WARNING: Loose debris may cause a catastrophic failure of
the blast wheel resulting in serious injury.
WARNING: Keep all guards in place - The 1-8DEZ is equipped
with guards or covers for parts that may be hazardous. If any
guards are removed for maintenance, verify that the guards
have been replaced and are functioning prior to using the 1-
8DEZ. Refer to drawings 421-0001 for correct placement of
guards, coverings and other 1-8DEZ component parts.
All personnel in the immediate work area must wear safety glasses with side
shields and hearing protection whenever the 1-8DEZ is blasting; protective
clothing is also recommended. Long sleeve shirts and safety shoes should be
worn. The abrasive used in the 1-8DEZ impacts the work surface at high velocity;
therefore any leakage during normal operation may sting personnel in the
surrounding area. The blast head must be sealed to the work surface during
operation to prevent abrasive leakage. Loose clothing, long hair and jewelry
should not be worn when operating or maintaining the 1-8DEZ.
Shot Blasting
10
