20
The time indications are based on uninterrupted operation. When the indicated number of working hours is not
achieved during the corresponding period, the period can be extended. However a full overhaul must be
carried out at least once a year. This technical inspection shall be carried out by the manufacturer or an
instructed person.
Due to different working conditions it can’t be foreseen how frequently inspections for wear check’s,
inspection, maintenance and repair works ought to be carried out. Prepare a suitable inspection schedule
considering your own working conditions and experience.
Pay attention to unusual noises or strong vibrations. Check for the cause of every big change. Call a technician
if you have doubts about the cause or when a repair without a technician seems not possible without damages.
Only use genuine Blastrac spare parts.
After use, clean the machine with the dust collector, so there is no dust on the machine.
See to it that any wastes or fibre residues do not remain in the machine.
Our specialists will be happy to assist you with more advice.
Prior to any repair works on the machine and its drives, secure the machine against unintentional
switching on. Put the machine to its safety off position.
The machine is in a safe condition when it cannot generate any hazard.
Further is advised:
Clean the machine every day with air and non-aggressive materials. Never use a high pressure water cleaner
to clean the machine.
Store the cleaned and dry machine in a dry and humid free room. Protect the electrical motors from moisture,
heat, dust and shocks. Remove the abrasive out of the abrasive storage hopper.
All repair work must to be done by qualified Blastrac personnel, this to guarantee a safe and reliable machine.
Any guarantee on the machine is expired when:
Non original Blastrac parts have been used
Repair work is not done by qualified Blastrac personnel
Changes, add on’s or conversions are undertaken without written permission of Blastrac BV
Screws, bolts etc. that have been removed must be replaced with those of the same quality, strength, material
and design.
Do not weld, flame cut or perform grinding works on or near the machine. Danger of fire or explosion exists!
Provide adequate ventilation when working in a confided space. Secure the maintenance area if necessary.
Follow additional operating and maintenance instructions of Original
Equipment Manufacturers if included during your service and
maintenance work.
