Blast-It-All LB4024, Manual

Page: 9 / 28

INSTALATION :
LITTLE BLASTER w/CARTRIDGE DUST COLLECTOR
1. Remove all shipping protection Check for any concealed shipping
damage, if discovered, report the damage to your freight carrier AS
Non-Disclosed Hidden Damage immediately.
2. Blast Cabinet should be placed in a desired location, away from any
water or moist environment. If moist compressed air is present at
this location, install a good moisture separator.
3. Install Air Controls
(READ INSTALLATION –“ Little Blaster™ AIR CONTROLS”)
4. Install Cartridge Dust Collector: Packaged with machine are bolts,
washers, nuts and gasket material. Apply gasket to back of cabinet
around large hole, press to make a firm bond to cabinet and squeeze
together at seam. Align the 4-hole bolt pattern of the Dust Collector
and install bolts, washers, and nuts. Tighten bolts and nuts securely.
5. Remove Window Frame/Window Glass and Install the Mylar Roll
into the Mylar Dispenser. Pull Mylar from the Mylar Dispenser
Across the Window Opening. Place the Window Glass/Window
Frame on Top of the Mylar, Securing with Plastic Knobs.
6. Install Gloves ( Watch the Video)
7. Plug electrical cord from side of dust collector into plug from light
box.
(READ OPERATION - “Little Blaster™ CARTRIDGE DUST COLLECTOR”)
8. Connect your air supply line to machine air inlet on left rear leg, we
recommend using 1/2" I.D. Hose or Pipe minimum supply line.
(Again, make sure your air supply line is free from oil and moisture).
(If not, install a good moisture separator).
Part #: 16-815 (DO NOT USE ANY QUICK DISCONNECT COUPLINGS)
9. Connect the electrical cord from light box to a grounded electrical
source.
120-volt/60 cycle, single phase
A 20 AMP breaker or fuse should be used.
MAKE SURE MACHINE HAS PROPER GROUND
10. Charge blast machine with abrasive. Pour media into cabinet
through one of the doors and fill to bottom of screen in sump of
cabinet. Media Sold Separately @ Blast-It-All Online Store
DO NOT FILL ABOVE SCREEN
.
*** READ BEFORE OPERATING EQUIPMENT ***
© 2020 Hess & Associates Man. # 561 v02-02 8/2020 Page 7