3
LANIOS
Part N
o
: 5160.01
8-port switch
SBL
1. Safety and operating instructions
When assembling, starting-up and adjusting the modules, it is necessary to consider the system specific references in
the manual instruction
The modules may only be installed and started up by authorized technical personnel. There are only permitted the
mounting styles indicated in the quick start guide, which is included each module.
When assembling the modules into the receiving points, the adherence of the EMC regulations is to be ensured.
The assembly and wiring have to be done without voltage. For installation, only the supplied accessories (DIN rail clip
with screws and 19“ accessories) may only be used.
All active modules may only be operated with the power supply HELIOS. To supply the module only the attached accessory
cables are used.
The mains voltage and the operating voltage of the modules working by DC have to be in complience to the operating
parameters described in the technical data.
With all work the defaults of the DIN EN 50083 have to be considered! Especially the safety relevant execution of the
DIN EN 60728-11[1] is necessary.
The unit should be mounted only vertically. The ventilation slots as well as the circulation perforation of the modules must
be kept absolutely free.
If installed in mounting cabinets a adequate heat circulation must be guaranteed. The mounting in closed cabinets with
no air exchange is
not allowed
.
For
DIN rail mounting
is important to note that between the heat sink and a neighboring building, a distance of 2 cm is
required. If the modules mounted on top of each, so to observe a distance of 20 cm from the bottom edge of the top
module to top edge of the lower module
For
19“ mounting
all devices in the rack must be fitted with 19“ Edge Guide. The sole panel mounting is not enough!
Furthermore, the operation of a fully occupied rack is only allowed with an underlying 1-U fan box (at least 3 fans,
176 mm deep).
2. Device variants
LANIOS
5160.01 8-port switch
3. General
The Smart Business Line (SBL) is a modern head end system, that is distinguished by its modular and compact design. A userfriendly
operating concept facilitates setup, configuration and maintenance of the system.
The module LANIOS is the 8-port Ethernet switch created for the SBL system.
4. Front view
LANIOS
12 VDC
I
II
III
IV
V
VI
VII
VIII
Port 1 ... 4
Power connectors (loop through)
LED “POWER“ (green)
Port 5 ... 8
