19
Responding to Problems
Error
Code
Error Description
What to do
F5
Inadequate water supply
Make sure the water input tap is totally open and that
there is no water cut.
Close the water input tap, separate the water input hose
from the tap and clean the filter at the connection end of
the hose.
Restart your machine. Contact an authorised service
agent if the error persists.
F3
Error of continuous water input
Turn the tap off.
Contact an authorised service agent.
F2
Waste water in the machine
cannot be drained
Water drain hose is clogged.
The filters of your machine might be clogged.
Power off-on your machine and activate the program
cancellation command.
If the error continues, contact an authorised service
agent.
F8
Faulty heater
Contact an authorised service agent.
F1
Alarm is active against water
overflow
Power off your machine and turn off the tap.
Contact an authorised service agent.
FE
Faulty electronic circuit
Contact an authorised service agent.
F7
Overheating
Contact an authorised service agent.
F9
Divisor position error
Contact an authorised service agent.
F6
Faulty heater sensor
Contact an authorised service agent.
If one of the monitor lights are and the Start/Pause light is blinking:
Your machine’s door is open. Shut the door.
If the machine won’t start:
Check if the plug is connected.
Check your indoor fuses.
Be sure that the water inlet tap is turned on.
Be sure that you have closed the machine door.
Be sure that you switched off the machine by pressing the Power On / Off button.
Be sure that the water inlet filter and the machine filters are not clogged.
If the lights don’t go out after a wash:
Check if the Power On/Off button has released yet.
If detergent residues are left in the detergent compartment:
Detergent has been added when the detergent compartment was wet.
If water is left inside the machine at the end of the program:
The water drain hose is clogged or twisted.
The filters are clogged.
The program is not finished yet.