Page 9
2. Fully extend the handlebars to their upright
position until you feel the mechanism lock
into place (Fig. 5).
Charging
Your XTR-Street should come charged out of the box. Bladez still recommends
charging the unit for 6-8 hours prior to first use! Bladez also recommends charging your
XTR-Street after every use and prior to storage.
Warning:
DO NOT
allow your Powerboard to go into deep discharge! – This will
damage the batteries.
Charging Instructions
Charging
1. Carefully remove the XTR-Street from the box.
2. Make sure the unit is turned OFF.
3. Open the charging plug by rotating the safety
cover clockwise as shown in arrow
from Fig. 6.
4. Locate the AC CHARGER and plug it into
wall. Insert the charger (the end with the
prongs inside of it) into the charging plug.
5. A red light (Charging Status Light) will come on the
Charger indicating that charging is in process as
shown in Fig 7.
6. Remove charger and close the safety cap.
7. You are now ready to ride the XTR-Street.
Note:
If the light turns green right away, this is because the unit was charged at the
factory. Please continue charging for 6-8 hours prior to initial use.
Fig. 5
Fig. 6
Charging
Status Light
Fig. 7
