15
STEP 6: Seat Assembly
Loosen the Pop Pin (4) and slide the Seat Slider
(9) into the Seat Post (8) at desired setting and
tighten the Pop Pin (4). Slide the Seat (12) onto
the post on the Seat Slider(9) and tighten the
nuts on both sides of the Seat (12) with the
wrench provided.
STEP 7: Water Bottle Holder Installation
Attach the Water Bottle Holder (72) onto the
right fork of the frame - there are two holes in
the fork to align the water bottle holder. Align
the Water Bottle Holder to the holes and secure
with 2 washers (74) and 2 Umbrella Screws (73).
STEP 8: Attach the Mount
There are two screws (77) located on the
Handlebar (2). Take these screws out and attach
the Computer Bracket (76) to the Handlebar (2)
with the two screws (77).
STEP 9: Attach the Computer
The Computer (75) comes with two batteries.
Pull off the back cover and install the batteries.
Replace Cover. Align the back of Computer
(75) with Computer Mount (76) and slide the
computer onto the computer mount. Connect
the computer cable with speed sensor cable
from the bike.
75
76
2
77