5
EN
Installing the Transmitter Batteries
Installing the Video Transmitter Antenna
Installing the Flight Battery
CAUTION:
Always disconnect the Li-Po battery from the quadcopter when not fl ying to avoid over-discharging the
battery. Batteries discharged to a voltage lower than the lowest approved voltage may become damaged, resulting
in loss of performance and potential fi re when batteries are charged.
1. Remove the battery door screw.
2. Slide the battery door down to open.
3. Install 4 AA alkaline batteries in the transmitter.
4. Re-install the battery door and battery door screw.
Replace the transmitter batteries when the transmitter
indicates low voltage. The right LED fl ashes and the
transmitter beeps when the battery voltage is low.
Install the video transmitter antenna in the top of the
quadcopter as shown.
NOTICE:
Never install the fl ight battery or power on
the quadcopter without the video transmitter antenna
installed. Doing so, even for a short time, will damage the
video transmitter.
1. Remove the battery compartment cover by pulling on the
edge of the cover to unsnap it from the frame.
2. Slide the fl ight battery into the quadcopter frame and
re-install the cover.
3. Lower the throttle to the lowest position.
4. Power on the transmitter.
IMPORTANT:
Always power the transmitter on
before
powering on the aircraft.
5. Connect the battery cable to the aircraft power lead,
noting correct polarity. Do not move the quadcopter until
the receiver initializes.
CAUTION:
Connecting the battery to the aircraft
power lead with reversed polarity will cause
damage to the power distribution board, ESCs and the
battery. Damage caused by incorrectly connecting the
battery is not covered under warranty.
6. The quadcopter motors will beep once and the receiver
status LED will glow solid red.
IMPORTANT:
If the receiver status LED fl ashes red, the
transmitter is not bound to the aircraft. See the
Binding
section to re-bind the aircraft to the transmitter.
