Blade BLH02000, Instruction Manual

Page: 6 / 15

6
EN
Transmitter Setup
Timer
Mode
Count Down
Time 4:00
Start Throttle Out
Over 25%
One Time Inhibit
Chan Travel Reverse
THR 150/150 Normal
AIL 148/148 Reverse
ELE 148/148 Normal
Chan Travel Reverse
RUD 148/148 Reverse
GER 100/100 Normal
AUX1 100/100 Normal
Servo Setup
FUNCTION LIST
D/R & Expo
Chan
Switch (B)
Pos D/R Expo
AILE
0 100/100 0
1 100/100 0
2 100/100 0
ELEV
0 100/100 0
1 100/100 0
2 100/100 0
SETUP LIST
F-Mode Setup
Switch 1
Inhibit
Switch 2 Inhibit
Model Type
Airplane
Channel Assign
Channel Input Confi g
1 Throttle
2 Aileron
3 Elevator
4 Rudder
5 Gear
Switch B
6 Aux 1 Switch H
Frame Rate
11ms
DSMX
DX6, DX7 (Gen 2), DX8 (Gen 2), DX9, DX18, DX20
Installing the Flight Battery
1. Set the motor arm switch to OFF (position 1).
2. Lower the throttle.
3. Power on the transmitter.
4. Attach hook material to the quadcopter frame and
loop material to the battery.
5. Install the fl ight battery on the quadcopter frame.
Secure the fl ight battery with a hook and loop strap.
6. Connect the battery cable to the aircraft power lead,
noting correct polarity.
The quadcopter utilizes an XT-60 connector. If your fl ight
battery uses an EC3
™ connector you may either use an
adapter, available in the Optional Parts list, or you may
connect the EC3 connector directly to the XT-60. The
round negative terminal of the EC3 fi ts in the angled
negative terminal of the XT-60 as shown below.
7. Do not move the quadcopter until the receiver initializes.
8. The quadcopter motors will emit initialization tones, indicating the ESCs are armed.
Switch Functions
Flight Mode Switch = Switch B
Motor Arm Switch = Switch H
CAUTION: Always disconnect the Li-Po battery from the quadcopter when not fl ying to avoid over-discharging
the battery. Batteries discharged to a voltage lower than the lowest approved voltage may become damaged,
resulting in loss of performance and potential fi re when batteries are charged.
CAUTION: Connecting the battery to the aircraft power lead with reversed polarity will cause damage to the
power distribution board, ESCs and the battery. Damage caused by incorrectly connecting the battery is not
covered under warranty.