12
PIC. 3
PIC.4
Generator ‘Earthing’
Always ensure that this generator is “Earthed”
BEFORE starting and using.
1. Ensure that engine is OFF when
fi
tting the
“Earth” stake and wire.
2. Attach the wire to the “Earth” point on the
generator, see Pic. 3.
3. Push the attached stake into the ground.
Ensure that this is not a trip hazard when near
the generator.
4. Ensure the generator is OFF and cool before
removing the “Earth” stake and wire.
Starting Your Generator
Warning:
Never start your generator without
“earth” attached.
1. Ensure the ”Earth” stake and wire are attached,
see Pic. 3.
2. Turn the engine switch on by pushing to ‘l’, see
pic 4.
3. Turn choke to start by sliding the choke lever
to the left, see Pic. 5.
4. Turn the fuel to ON by turning the fuel tap
lever, see Pic. 5.
5. Pull the recoil starter slowly until engaged,
then pull briskly. This step may need to be
repeated until generator engine starts, this is
can take up to about 12 pulls.
Warning:
Never pull the recoil once the
engine has started. Any damage caused will
not be covered under warranty.
6. Allow engine to run up to speed, this usually
takes up to about 20 seconds.
7. Turn choke to RUN by sliding the choke lever to
the right.
8. The generator will now be idling and ready
for use.
‘Earth’ point attach the
‘Earth’ wire here
PIC. 5
Turn choke
to start
Turn fuel to ON
Turn engine switch to on ‘|’