E
Bi
ke
T
un
in
g
A
pp
12
Combination
If the module is invisible, it can be made visible by a combination of the manual control. In the
factory state, the light button must be pressed 6 times. If the combination is to 0, then the
module can only be made visible via the reset connector.
6.3. R
ESET
MODULE
The module can only be returned to factory condition via the black plug. For this, the two
contacts must be connected to a conductive material, e.g. a key. Another reset can only be
made after the e-bike has been restarted. Total distance and battery cycles won’t be reset.
6.4. D
IVIDE
|
FREEZE
AND
MAXIMUM
SPEED
The actual maximum speed with activated tuning depends on the engine and chainring. The
value set via the app is used to set the divider.
The factory settings should only be changed if there are problems with the support or error
messages appear.
The division is determined by two parameters divided by the divider and the speed at which it is
divided. The divider is determined by the set maximum speed (
!
).
Freezing means that the speed remains constant after exceeding the set value.
6.5. P
IN
Before the data of a module can be read out, a PIN must be entered. The PIN is always 6 digits
and can be changed in the app. If the entered new PIN is too short, zeros are prefixed, e.g.
"123" is entered, the PIN is automatically changed to "000123". The PIN can be reset to
"000000" via the reset connector.
6.6. T
UNING
ACTIVATION
Tuning activation via the app will be deactivated, if the tuning activation with the e-bike is
activated.
All set conditions must be met during the tuning activation with the e-bike (AND link). A
maximum of 5 seconds may elapse between two actions, otherwise the counters will be reset.
Divider = Max
speed
25