Blackmagicdesign Pocket UltraScope, Operation Manual

Page: 10 / 35

How to Install on a Windows PC
10
Update your USB 3.0 Firmware
Install the Updates
Now you have downloaded the correct updates for your computer’s NEC USB 3.0 chip, the next
step is to install them onto your computer.
• Before you install the software driver, disconnect all USB 3.0 devices from your computer
• Run the 32 or 64 bit software driver installer as appropriate for your version of Windows.
The installer is named RENESAS-USB3-Host-Driver-2040-setup
.
• After installing the drivers, navigate to the Firmware folder, which was previously
extracted, and run the firmware update utility named F302508FWUP1. Your machine will
require a reboot after the update.
• Verify that the driver and firmware updates have been successful by running the USB 3.0
Host Controller Utility again as in Step 1.
3