Using the ATEM 1 M/E Broadcast Panel
51
Button Mapping
ATEM software and hardware control panels support button mapping so you can assign your most
important sources, especially cameras, to the most accessible buttons in the program and preview rows.
Occasional sources can be assigned to less prominent buttons. Button mapping is set independently for
each control panel so button mapping set on a software control panel will not affect the button mapping
set on a hardware control panel.
ATEM Broadcast Panel Button Mapping and Button Brightness Level
Button Mapping on ATEM Broadcast Panels is easy. On the ATEM Broadcast Panel, go to the System
Control block and press PANEL SETUP followed by BUTTON MAP. Once in the button map menu, you
will notice the System Control window shows a Button number and an Input number. Turn the knob under
Selected Button to select the desired button which you want to associate with an input. You can do the
same thing by selecting the desired button in the Select row. The buttons in the Select row correspond to
the buttons directly below them in the Preview and Program rows. Next, turn the knob under Selected Input
to set an input for the selected button. Choose another button you wish to map and repeat until all the
buttons are mapped with desired inputs.
If you want to change the brightness of the buttons, press the BUTTON LEVEL button and rotate the knob
under Brightness until the desired brightness level is seen.
Once you have configured all the button settings, press the SAVE button to save the new button map and
brightness level, or REVERT to discard changes.
Button Mapping
Selected Button
Selected Input
Button 1
Input 1
Camera 1
ATEM Broadcast Panel button mapping
