15
1.877.877.2269
BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
CHAPTER 3: CONNECTIONS
3.1 ONE-TO-ONE MAPPING EXTENSION
FIGURE 3-1. ONE-TO-ONE MAPPING EXTENSION
Use this to pair a single set of TX and RX. The default video channel on each unit is 1. This can also be adjusted on multiple RXs to
match a single TX, then press the “SET/RESET” button on the RX unit(s).
Fiber
Copper
OR
NOTE: The TX-RX link can use fiber
OR copper cable, but not both at
the same time.
FIGURE 3-2. ONE-TO-ONE CONNECTION
3.2 MULTICASTING
Multicasting enables you to install a matrix of TX and RX units for use as an extender matrix system over an IP network. A multicasting
application requires a Gigabit/1000-Mbps network switch.
For multicast-matrix installation, the Gigabit Managed Switch or Gigabit Smart Switch must support the IGMP V2 querier function and
Jumbo Frame (at least 8K) is required.
For each Transmitter (TX), set a unique video channel number ranging from 01–99 to avoid channel conflict. Each Receiver’s (RX) video
channel must correspond to the Transmitter’s (TX) video channel whose video content will be displayed on RX’s display. Press the “ SET/
RESET ” button of the RX unit to implement extension linking.
A multicasting application diagram is shown on the next page.
