lights will turn on, the heater or air
conditioner will turn on (if pre-
selected) and run for the pre-
programmed time (12 or 24 minutes). If
the engine fails to start on the first
attempt, it will repeat the starting
procedure 2 more times. If the vehicle
fails to start after a total of 3 times the
system will shut down.
Driving vehicle after Remote Starting:
Unlock the door by pressing button 2* on
the remote transmitter. Enter vehicle, turn
ignition key to the on position (Note: Do not
turn the key all the way to the start position as
you may damage the starter).
Once the ignition key is turned to the on
position, press the brake pedal and shift the
car into the proper gear and you may now
drive the vehicle (Note: If brake pedal is
pressed prior to turning on ignition, engine will
turn off).
REMOTE ENGINE SHUTDOWN
If the vehicle has been remotely started and
you desire to turn the vehicle off, simply press
and hold button 4 on the remote transmitter
for three seconds.After the motor has turned
off the doors will relock*. This feature must be
programmed during installation.
AUTO COLD START
This feature allows the system to start and
run the vehicle every one or two hours
(selectable by your installer) for a period of
24 hours.This allows the engine to remain at
an operational temperature in extremely
cold weather.
Engaging the Auto Cold Start feature:
To turn Auto Cold Start on:
1. Press and hold the brake pedal.
2. While holding the brake pedal down,
push the Valet switch and transmitter
button 2 for two seconds.
• The parking lights will flash four times
to indicate the Cold Start feature is
engaged.
3. Release the brake pedal.
Disengaging the Auto Cold Start feature:
The Auto Cold Start feature can be
deactivated in one of three ways:
• Press the brake pedal.
• Turn on the ignition.
• Remote start the vehicle using the
transmitter.
STOP AND GO
The Stop and Go feature allows the vehicle
to remain running without use of the ignition
key during short stops.
To activate the Stop and Go feature:
1. With engine running push transmitter
button 4 (on FM 2-way press button 2.).
• The parking lights will turn on.
2. Remove the key from the ignition.
3. Exit the vehicle and lock the doors
manually or using transmitter button 1*.
To resume driver control:
1. Unlock the doors manually or by
pressing transmitter button 2*.
2. Turn on the ignition.
• The vehicle resumes driver control.
3
*
Optional Feature
