3
5-Pin Door Lock Connector:
Plug-in
connector port for door lock harness.
• WHITE WIRE - Lock relay normally closed
(87a).
• GREEN WIRE - Lock relay common (30).
• BLUE WIRE - Unlock relay common (30).
• BROWN WIRE - Unlock relay normally
closed (87a).
• VIOLET WIRE - Lock/unlock relays
normally open (87).
Starter Defeat Connectors
Using a volt/ohm meter locate the starter
wire (normally a heavier gauge wire) at the
ignition switch.This wire will show +12V only
during cranking. When this wire is cut the
vehicle will be unable to start.
Cut the BROWN starter disable wire (with
the two female connectors), and connect one
side to the vehicle’s starter wire coming from
the key switch. Connect the other BROWN
wire to the wire going to the starter.
Plug the female connectors on the BROWN
wires to the .250 male spade lugs on the
module. With the BROWN wires connected
to the module, the vehicle should be able to
start.
Plug in Connectors
2-Pin Red Connector:
Plug-in connector
port for LED. Mount LED in an area where it
may be easily seen from either side of the
vehicle.
2-Pin Blue Connector: Plug-in connector
port for valet switch. Mount switch in an area
that is easily accessible from the driver’s seat.
4-Pin White Connector A: Plug-in connector
port for dual stage shock sensor.
4-Pin White Connector B: Plug-in connector
port for optional dual stage radar sensor.
Adding Transmitters
To add a new transmitter to the system have
the desired transmitters ready and follow the
Code Learning sequence.
To enter Code Learning Mode:
1. Turn the ignition on, off, on, off and leave
on.
• The siren will chirp 3 times.
2. Press and hold the Valet switch for 5
seconds.
• The siren will chirp 5 times.
3. Press the Lock Button on the transmitter.
• The siren will chirp once.
4. Press Lock Button on the transmitter
again.
• The siren will chirp twice.
5. Repeat steps 3 and 4 for each additional
transmitter.
6. Turn off the ignition.
• The siren will chirp 3 times.
Two Car Operation
With the supplied 5-button transmitter it is
possible to control a second vehicle using the
same primary transmitter. For Car 2 enter
the Code Learning Mode as described above
then substitute the steps below for 3 and 4
above.
3. Press Button 5 twice followed by the Lock
Button.
• The siren will chirp once.
4. Press Button 5 twice followed by the Lock
Button.
• The siren will chirp twice.
