Remote Start Operation
Important: The system should be placed
into the valet mode when parked inside a
garage or being left for service. Only
start the vehicle in a well ventilated area.
Do not use in a closed garage or indoors.
Be sure to familiarize yourself with all
features prior to using this product.
REMOTE STARTING THE VEHICLE
To remote start the vehicle:
Press button 2 on the transmitter.
• The siren chirps 3 times.
• The parking lights turn
on.
• Approximately 2
seconds later the
system will attempt
to start the vehicle.
• Once the car has started, the heater or
air conditioner will turn on and run for
the preprogrammed time (15 or 25
minutes). If the engine fails to start on
the first attempt, it will repeat the
starting procedure 2 more times. If the
vehicle fails to start after a total of 3
times the siren will chirp 4 times.
Driving vehicle after Remote Starting:
Unlock the door by pressing button 1 on
the remote transmitter. Enter vehicle, turn
ignition key to the on position (Note: Do not
turn the key all the way to the start position as
you may damage the starter).
Once the ignition key is turned to the on
position, press the brake pedal and shift the
car into the proper gear and you may now
drive the vehicle (Note: If brake pedal is
pressed prior to turning on ignition, engine will
turn off).
REMOTE ENGINE SHUTDOWN
If the vehicle has been remotely started and
you desire to turn the vehicle off, simply
press button 2 on the remote transmitter.
After the motor has turned off the doors
will relock (optional).
AUTO COLD START
Cold start feature allows the remote starter
to start and run the vehicle every one or
two hours (selectable by your installer) for a
period of 24 hours.This allows the engine to
remain at an operational temperature in
extremely cold weather. Auto Cold Start must
be enabled during installation or it cannot be
engaged.
Engaging the Auto Cold Start feature:
To turn Auto Cold Start on:
While holding the brake pedal down, push
the program switch and transmitter button
2 for two seconds.
• The parking lights will flash three times.
• The siren will chirp three times.
• The engine will start and run for thirty
seconds to indicate the Cold Start
feature is engaged.
Disengaging the Auto Cold Start feature:
The Auto Cold Start feature can be
deactivated in one of three ways:
• Press the brake pedal.
• Turn on the ignition.
• Remote start the vehicle using the
transmitter.
4
Press
