Black Ridge BR105D, Manual

Page: 12 / 20

12 13
PIC. 8
STARTING AND STOPPING YOUR AIR
COMPRESSOR
Pic. 8
NOTE: Always ensure that you plug your air compressor into
a standard 240V AC power point. Never use an extension
cord as this can lead to a voltage drop which may cause
power loss and over heating. Use a longer air hose if you
need to get closer to your work area.
Always start and stop the compressor using the ON/OFF
switch on the Pressure Switch (Pic. 8). Damage caused by not
using this switch will not be covered by warranty.
To turn your air compressor ON;
Lift up the red ON / OFF switch on top of the pressure switch
To turn your air compressor OFF;
Push down the red ON / OFF switch on top of the pressure
switch
AIR FILTER
The supplied air filter must be used.
Failure to do so may result in irreparable damage and will
void the warranty, Pic. 7
To install;
1. Carefully screw supplied air filter into the threaded hole
on the top of the pump head. This only needs to be done
up by hand. Do not use tools to tighten air filter.
NOTE: Do not OVER TIGHTEN as this may damage the air
filter or cylinder head which will NOT be covered under
warranty.
Lift switch
up for on
Push switch
down for
PIC. 7