5
High Performance IR CCTV Bullet Camera User Manual
SECTION 2: INSTALLATION
3.
Drill a 3/4” hole for the drop cable, if necessary.
4.
Anchor the mounting plate to the mounting surface using the screws provided, or screws better suited for the surface
structure.
5.
Route the drop cable through the hole through the base plate, or through the cable guide in the mounting bracket, then
attach the camera to the mounting plate using the four (4) machine screws provided.
6.
Connect the camera drop cable to video and power cables as required.
NOTE
Drop cable connectors are not waterproof.
2.3 Camera adjustments
In this procedure, set the camera to point at your surveillance target. Rotate the far - near and tele - wide rings to frame the video
image.
1.
Apply power to the camera.
2.
Observe video from your camera on a monitor.
a.
If using a hand-held CCTV video setup monitor with your camera:
i.
Remove the cover to the OSD control panel by unscrewing it counter clockwise.
BLK-CPB700R65 OSD Controls
BLK-CPB700R150 and BLK-CPB700R300 OSD Controls
ii.
Connect the BNC adapter cable to the VIDEO TEST port on the OSD control panel.
iii. Connect a CCTV setup monitor to the BNC adapter cable.
b.
If using a CCTV video system monitor to setup your camera, connect the video output of the camera to your CCTV
monitor.
