TROJAN.
INSTRUCTION MANUAL
33
Ailerons : 15mm up 15mm down
Elevator : 15mm up 15mm down
Rudder : 20mm right 20mm left
1. We highly recommend setting up a plane
using the control throws listed.
2. The control throws should be measured
at the widest point of each control surface.
3. Check to be sure the control surfaces
move in the correct directions.
CONTROL THROWS
.
1. Completely charge your transmitter and
receiver batteries before your first day of flying.
2. Check every bolt and every glue joint in
your plane to ensure that everything is tight
and well bonded.
3. Double check the balance of the
airplane.
4. Check the control surface.
5. Check the receiver antenna . It should
be fully extended and not coiled up inside the
fuselage.
6. Properly balance the propeller.
PRE-FLIGHT CHECK.
Aileron Control
20
20
We wish you many safe and enjoy-
able flights with your T28-TROJAN.
Summary of Contents for T-28 Trojan 120
