TROJAN.
INSTRUCTION MANUAL
25
3. Mark the shape of the vertical on the left
and right side of the rudder on to the horizon-
tal stabilizer using a felt-tip pen.
4. Now, remove the rudder and using a
modeling knife, carefully cut just inside the
marked lines and remove the film of the rudder.
Just as you did with the horizontal stabilizer,
make sure you only press hard enough to cut
the film, not the balsa rudder.
Also carefully remove the covering from
below the lines as you drew as same picture
below.
1. Using a modeling knife cut away the
covering from the end of fuselage for the rud-
der hinge.
2. Put the rudder into the fuselage as same
as picture below.
Pen.
Hinge slot.
Top side.
Hinge.
5. Put the vertical stabilizer back in
place. Using a triangle, check to ensure
that the vertical stabilizer is aligned 90 degree
to the horizontal stabilizer.
Remove
covering.
Remove
covering.
Summary of Contents for T-28 Trojan 120
